Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| ur10_robot_arm:drawing_with_the_ur10_v2 [2023/02/08 04:42] – [Connect the computer to the robot] formlab | ur10_robot_arm:drawing_with_the_ur10_v2 [2023/02/08 07:10] (current) – [Connect the computer to the robot] formlab | ||
|---|---|---|---|
| Line 33: | Line 33: | ||
| Turn on the robot. | Turn on the robot. | ||
| + | |||
| + | == Connect the computer to the robot == | ||
| + | |||
| + | * Use an ethernet cable going over a switch. Connecting directly to the robot doesn' | ||
| + | * **Don' | ||
| + | * If you use a laptop: Use the MiniDisplay to Ethernet adapter that is labeled Formlab. I had another one fail (the same model), which is annoying to debug. | ||
| + | |||
| + | * IP address: 192.168.185.99 | ||
| + | * Subnet masker: 0.0.0.0 | ||
| + | * Default Gateway: 0.0.0.0 | ||
| + | * Preferred DNS Server: 0.0.0.0 | ||
| + | * Alternative DNS Server: 0.0.0.0 | ||
| + | |||
| == Define the TCP == | == Define the TCP == | ||
| Line 40: | Line 53: | ||
| * Save the settings in the installation tab. | * Save the settings in the installation tab. | ||
| - | == Connect the computer to the robot == | ||
| - | * Use an ethernet cable going over a switch. Connecting directly to the robot doesn' | ||
| - | * Use the MiniDisplay to Ethernet adapter that is labeled Formlab. I had another one (the same model) fail, which is annoying to debug. | ||
| == Get the current pose into Grasshopper == | == Get the current pose into Grasshopper == | ||