Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| ur10_robot_arm:drawing_with_the_ur10_v2 [2023/02/08 06:46] – formlab | ur10_robot_arm:drawing_with_the_ur10_v2 [2023/02/08 07:10] – [Connect the computer to the robot] formlab | ||
|---|---|---|---|
| Line 37: | Line 37: | ||
| * Use an ethernet cable going over a switch. Connecting directly to the robot doesn' | * Use an ethernet cable going over a switch. Connecting directly to the robot doesn' | ||
| - | * If you use a laptop: Use the MiniDisplay to Ethernet adapter that is labeled Formlab. I had another one (the same model) | + | |
| + | The robot won't be able to connect to the network. Use a separate switch or remove all the connections except the one going to the robot and the computer. | ||
| + | | ||
| + | |||
| + | * IP address: 192.168.185.99 | ||
| + | * Subnet masker: 0.0.0.0 | ||
| + | * Default Gateway: 0.0.0.0 | ||
| + | * Preferred DNS Server: 0.0.0.0 | ||
| + | * Alternative DNS Server: 0.0.0.0 | ||