Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
slicers:slicers [2020/08/03 02:19] – formlab | slicers:slicers [2020/08/03 05:08] (current) – formlab | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Cura ===== | ===== Cura ===== | ||
- | ==== per model settings ==== | + | ==== Per model settings ==== |
{{: | {{: | ||
Use different slicer settings in the volume of a selected object. | Use different slicer settings in the volume of a selected object. | ||
Line 20: | Line 20: | ||
{{: | {{: | ||
+ | When you're using Gradual Infill Steps in your main model, don't forget to add '' | ||
+ | ==== Calibrating for correct dimensions ==== | ||
+ | * Isolate a small piece of your model which you can use for a fit-test. | ||
+ | * In Cura, set the '' | ||
+ | * Print the test piece and measure it with calipers. | ||
+ | * If the dimensions are different than the CAD model, adjust the horizontal offset. | ||
+ | * If the dimensions are the same as the CAD model, but it doesn' | ||
+ | * |