Differences

This shows you the differences between two versions of the page.

--- other:other [2019/08/07 07:51] – formlab
+++ other:other [2021/10/09 02:08] – [Other] formlab
@@ Line 2: / Line 2: @@
-- [[Hard drive based rotary table]]
+  * [[other:Hard drive based rotary table]]
-- [[LMI rotary table]]
+  * [[other:LMI rotary table]]
+  * [[other:KiCad Overview]]
+  * [[other:3D printing a single line]]
+  * [[https://www.youtube.com/watch?v=9AaujAPghhE|Casting aluminum from a 3D print]]
+  * [[other:Raspberry Pi video looper]]
+===== Sanding PLA =====
+{{:other:3d_print_sanded.jpg?400|}}\\
+Sanding 3D prints makes it appear matte.\\
+{{:other:sanding_pla.jpg?400|}}\\
+Removing material is best done by a sanding disk on a Dremel.
+  * Put on eye protection.
+  * Set the speed low (the dial should indicate the number 10). This is to keep the temperature low in order to avoid melting the plastic. This way it chips off, rather than gunking up into blobs.
+  * Make several light passes. A spray of tiny plastic particles should come off at each pass.
+  * The Dremel leaves a rough surface. Clean it up with a regular light sanding.
+===== Website =====
+Formlab - Grav website CMS system
+  * Main page: blog
+  * child pages: item
+===== Assortments =====
+  * Hex socket cap bolts ([[https://docs.rs-online.com/b3b9/0900766b815834db.pdf|RS-components - 545 Piece stainless steel bolt kit]])
+    * M3 x 6, 8, 12
+    * M4 x 8, 12, 20
+    * M5 x 10, 12, 16, 20
+    * M6 x 12, 16, 20, 25
+  * Hex socket cap bolts (larger) ([[431 piece Stainless Steel Screw/Bolt Kit|RS-components - 431 piece Stainless Steel Screw/Bolt Kit]])
+    * M6 x 12, 16, 20, 25, 40
+    * M8 x 16, 20, 25, 30
+    * M10 x 20, 30, 40, 60
+    * M12 x 20, 40, 60
+  * Nuts ([[https://docs.rs-online.com/3601/0900766b815832db.pdf|RS-components - 1710 piece stainless steel hex kit]])
+    * M2
+    * M2,5
+    * M3
+    * M4
+    * M5
+    * M6
+    * M8
+    * M10