Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ur10_robot_arm:ur10_robot_arm [2020/08/04 02:50] – [Physicial setup] formlab | ur10_robot_arm:ur10_robot_arm [2021/01/12 01:53] – [Pen plotter attachment] formlab | ||
---|---|---|---|
Line 9: | Line 9: | ||
===== future tool heads ===== | ===== future tool heads ===== | ||
* 3D scanner tool head | * 3D scanner tool head | ||
- | * | ||
- | ===== Brush attachment ===== | ||
+ | ===== Broom handle attachment ===== | ||
+ | {{: | ||
+ | {{: | ||
===== 3D print attachment ===== | ===== 3D print attachment ===== | ||
In development | In development | ||
+ | {{: | ||
===== Pen plotter attachment ===== | ===== Pen plotter attachment ===== | ||
+ | {{: | ||
+ | Used by [[http:// | ||
+ | |||
+ | [[Drawing with the UR10]] | ||
===== Webcam attachment ===== | ===== Webcam attachment ===== | ||
+ | {{: | ||
+ | {{: | ||
===== DSLR attachment ===== | ===== DSLR attachment ===== | ||
===== Hole drilling attachment ===== | ===== Hole drilling attachment ===== | ||
+ | {{: | ||
{{: | {{: | ||
- | This tool head was made to drill a grid of almost 500 holes into the base plate of the thermoform machine. | + | This tool head turns the robot into an automated hole drilling machine. Good for elaborate hole patterns that would be tedious to do manually. |
+ | |||
+ | Based on [[https:// | ||
+ | |||
+ | The 3D printed part attaches | ||
+ | |||
+ | Download | ||
+ | Attach | ||
+ | Attach the largest part to the tool changer with 4 M5x16 low profile bolts and 4 M4 nuts | ||
+ | |||
+ | |||
+ | === Applications === | ||
- | ==== Physicial setup ==== | + | |
- | | + | |
- | * {{: | + | |
- | The Dremel is strapped to the upper arm of the robot and secured with zip ties, using a curved block of foam. | + | |