prepare_for_3d_printing:prepare_for_3d_printing
This is an old revision of the document!
Table of Contents
Prepare for 3D printing
Prepare your 3D mesh
- watertight
- not too many intersections
- avoid small details (0.8mm minimum detail, but tall objects should be thinker)
- if part snaps together with other part: allow clearance
- if part snaps together with other part: make sure the part can be inserted
Slicing tips
- If Cura is slow: set the option “Infill > Skin Edge Support layers” to 0
prepare_for_3d_printing/prepare_for_3d_printing.1715585931.txt.gz · Last modified: by formlab