Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
isel_icv4030:engraving_large_pockets [2020/02/19 06:53] – formlab | isel_icv4030:engraving_large_pockets [2020/02/19 06:54] (current) – formlab | ||
---|---|---|---|
Line 7: | Line 7: | ||
* Set bottom height to the selected contour with an offset of -3mm. | * Set bottom height to the selected contour with an offset of -3mm. | ||
* under radial stock to leave, enter the radius of the V-bit at 3mm from the tip | * under radial stock to leave, enter the radius of the V-bit at 3mm from the tip | ||
- | * to calculate | + | * to calculate |
* {{: | * {{: | ||
* **OP 2**: Engraving operation with V-bit | * **OP 2**: Engraving operation with V-bit |