hyrel:your_first_print

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
hyrel:your_first_print [2020/10/12 06:37] – [3. Set up Repetrel] formlabhyrel:your_first_print [2020/10/12 06:39] (current) – [3. Set up Repetrel] formlab
Line 33: Line 33:
     - Raise the bed until the paper is lightly pinched between the nozzle and the bed.     - Raise the bed until the paper is lightly pinched between the nozzle and the bed.
     - Un-click ''Enable Z-calibration'' to set the current position as Z-ZERO.     - Un-click ''Enable Z-calibration'' to set the current position as Z-ZERO.
-  - Set nozzle diameter in the head-control section <wrap hi>(picture)</wrap>+  - Set nozzle diameter to 1.5mm in the head-control section <wrap hi>(picture)</wrap>
  
 ===== 3. Load 3D model ===== ===== 3. Load 3D model =====
  • hyrel/your_first_print.1602509873.txt.gz
  • Last modified: 2020/10/12 06:37
  • by formlab