Differences

This shows you the differences between two versions of the page.

--- hyrel:your_first_print [2020/10/12 06:02] – [3. Set up Repetrel] formlab
+++ hyrel:your_first_print [2020/10/12 06:39] (current) – [3. Set up Repetrel] formlab
@@ Line 16: / Line 16: @@
 ===== 2. Prepare the material =====
-  - Have a cylinder filled plasticine on hand. If not, [[load the plasticine yourself]].
+  - Have a cylinder filled plasticine on hand. If not, [[hyrel:plasticine|load the plasticine yourself]]
   - Make sure it has a nozzle diameter of 1.5mm.
   - Attach it to the ''EMO-25'' tool head.
@@ Line 26: / Line 26: @@
     - //Repetrel is the software that slices the 3D model and controls the printer.//
   - Home the Z-axis (Set extruder head height).
-      - Put a piece of paper under the nozzle.
+    - Put a piece of paper under the nozzle.
-      - Click ''Enable Z-calibrate''. When the button is red and the arrow on it's right is lit up yellow, It is now possible to //carefully// raise the bed to the nozzle.
+    - Click ''Enable Z-calibrate''. When the button is red and the arrow on it's right is lit up yellow, It is now possible to //carefully// raise the bed to the nozzle.
-        * The arrows show the motion from the perspective of the table:
+      * The arrows show the motion from the perspective of the table:
-        * UP = closer to the nozzle
+      * UP = closer to the nozzle
-        * DOWN = further away from the nozzle
+      * DOWN = further away from the nozzle
-      - Raise the bed until the paper is lightly pinched between the nozzle and the bed.
+    - Raise the bed until the paper is lightly pinched between the nozzle and the bed.
-      - Un-click ''Enable Z-calibration'' to set the current position as Z-ZERO.
+    - Un-click ''Enable Z-calibration'' to set the current position as Z-ZERO.
+  - Set nozzle diameter to 1.5mm in the head-control section <wrap hi>(picture)</wrap>
 ===== 3. Load 3D model =====