Differences

This shows you the differences between two versions of the page.

--- ultimaker_s5:ultimaker_s5 [2019/09/23 02:17] – formlab
+++ ultimaker_s5:ultimaker_s5 [2020/05/25 02:59] – formlab
@@ Line 1: / Line 1: @@
 ====== Ultimaker S5 ======
 {{:ultimaker_s5:ultimaker-s5.jpg?nolink&200|}}
+  * Max Build Volume: ''330 x 240 x 300mm''
+[[:How much does FDM printing cost?]]
+----
 ===== Maintenance =====
 ==== Every 2 months ====
   * [[https://ultimaker.com/en/resources/52604-clean-the-printer|Clean printer]]
-  * [[https://ultimaker.com/en/resources/52605-lubricate-the-axles|Lubricate axles]]
+    * wash build plate with warm water
+    * heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel)
+    * clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube.
+  * [[https://ultimaker.com/en/resources/52605-lubricate-the-axles|Lubricate axles]]
+    * clean all smooth axles with a paper towel
+    * one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute.
 ==== Every 6 months ====
-  * [[https://ultimaker.com/en/resources/52605-check-for-play-on-axles|Check for play on axles]]
+  * [[https://ultimaker.com/en/resources/52606-check-for-play-on-the-axles|Check for play on axles]]
   * [[https://ultimaker.com/en/resources/52607-check-the-tension-of-the-short-belts|Check tension of short belts]]
   * [[https://ultimaker.com/en/resources/52609-check-for-debris-in-the-front-fan-of-the-print-head|Check for residue in front fan of print head]]