Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
ultimaker_original:maintenance [2020/01/08 07:45] – formlab | ultimaker_original:maintenance [2020/01/08 07:48] (current) – formlab | ||
---|---|---|---|
Line 4: | Line 4: | ||
* level bed | * level bed | ||
* clean glass print bed with warm water | * clean glass print bed with warm water | ||
- | * clean and lubricate axles | + | * clean and lubricate axles. Only add green grease to the lead screw |
- | * hot and cold nozzle | + | * [[https:// |
+ | * Check feeder and clean if necessary | ||
Less often | Less often | ||
Line 12: | Line 13: | ||
* check that print head is parallel with the other axles. Use the wooden helper pieces. | * check that print head is parallel with the other axles. Use the wooden helper pieces. | ||
* Change heat brake plastic thingy | * Change heat brake plastic thingy | ||
+ | * replace Bowden tube |