ultimaker_3_extended:ultimaker_3_extended

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
ultimaker_3_extended:ultimaker_3_extended [2019/09/23 02:00]
formlab [Maintenance]
ultimaker_3_extended:ultimaker_3_extended [2020/05/25 02:58]
formlab
Line 1: Line 1:
 ====== Ultimaker 3 Extended ====== ====== Ultimaker 3 Extended ======
 {{:ultimaker_3_extended:ultimaker_3_extended.png?nolink&200|}} {{:ultimaker_3_extended:ultimaker_3_extended.png?nolink&200|}}
 +
 +
 +  * Max Build Volume: ''215 x 215 x 300mm''
 +
 +[[:How much does FDM printing cost?]]
 +
 +----
  
 ===== Maintenance ===== ===== Maintenance =====
-==== Monthly ==== +==== Every 2 months ==== 
-  * Clean printer+  * [[https://ultimaker.com/en/resources/23131-clean-the-printer|Clean printer]] 
 +    * wash build plate with warm water 
 +    * heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel) 
 +    * clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube.
   * [[https://ultimaker.com/en/resources/23130-lubricate-the-axles|Lubricate axles]]    * [[https://ultimaker.com/en/resources/23130-lubricate-the-axles|Lubricate axles]] 
 +      * clean all smooth axles with a paper towel
 +      * one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute.
  
  
-==== Every months ==== +==== Every months ==== 
 +  * [[https://ultimaker.com/en/resources/52500-check-for-play-on-axles|Check for play on axles]] 
 +      * [[https://ultimaker.com/en/resources/50871-check-for-play-on-axles|calibrate axles if play detected]] 
 +  * [[https://ultimaker.com/en/resources/39664-check-the-tension-of-the-short-belts|Check tension of short belts]] 
 +  * [[https://ultimaker.com/en/resources/50869-check-for-residue-in-the-front-fan-of-the-print-head|Check for residue in front fan of print head]] 
 +  * [[https://ultimaker.com/en/resources/52502-check-the-quality-of-the-silicone-nozzle-cover|Check quality of silicone nozzle cover]] 
 +  * [[https://ultimaker.com/en/resources/23132-clean-the-print-cores|Clean print cores]] 
 +  * [[https://ultimaker.com/en/resources/52503-lubricate-the-lead-screw-of-the-z-motor|Lubricate lead screw Z motor]]
 ==== Yearly ==== ==== Yearly ====
  
 +  * [[https://ultimaker.com/en/resources/52504-clean-the-feeders|Clean feeders]] 
 +  * [[https://ultimaker.com/en/resources/52505-replace-the-bowden-tubes|Replace Bowden tubes]]
  • ultimaker_3_extended/ultimaker_3_extended.txt
  • Last modified: 2020/06/23 04:11
  • by formlab