Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ultimaker_3_extended:ultimaker_3_extended [2019/09/23 01:55] – formlab | ultimaker_3_extended:ultimaker_3_extended [2019/09/24 03:21] – [Every 6 months] formlab | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Maintenance ===== | ===== Maintenance ===== | ||
- | * [[monthly]] | + | ==== Every 2 months ==== |
- | * [[every 3 months]] | + | * [[https:// |
- | * [[yearly]] | + | * wash build plate with warm water |
+ | * heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel) | ||
+ | * clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube. | ||
+ | * [[https:// | ||
+ | * clean all smooth axles with a paper towel | ||
+ | * one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute. | ||
+ | |||
+ | ==== Every 6 months ==== | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | ==== Yearly ==== | ||
+ | |||
+ | * [[https:// | ||
+ | * [[https:// |