tripodmaker:maintenance

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
tripodmaker:maintenance [2021/04/08 07:53] – [Clean drive gear] formlabtripodmaker:maintenance [2021/04/08 07:57] (current) – [Clean drive gear] formlab
Line 47: Line 47:
   * In the print panel of Repetier-Host, **extrude ''2,5''mm** (the speed is not important). This rotates the extruder gear just enough to clean the next section   * In the print panel of Repetier-Host, **extrude ''2,5''mm** (the speed is not important). This rotates the extruder gear just enough to clean the next section
   * Keep cleaning until the whole gear is free from plastic.   * Keep cleaning until the whole gear is free from plastic.
 +
 +{{:tripodmaker:cleaning_extruder_gear_web.jpg?400|}}\\ Easiest entrance for the pick.
  • tripodmaker/maintenance.txt
  • Last modified: 2021/04/08 07:57
  • by formlab