slicers:slicers

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
slicers:slicers [2020/08/03 02:19] formlabslicers:slicers [2020/08/03 05:08] (current) formlab
Line 20: Line 20:
 {{:slicers:per_model_settings_-_settings.png?600|}}\\ {{:slicers:per_model_settings_-_settings.png?600|}}\\
  
 +When you're using Gradual Infill Steps in your main model, don't forget to add ''Gradual Infill Steps: 0'' to the per model settings
  
 +==== Calibrating for correct dimensions ==== 
 +  * Isolate a small piece of your model which you can use for a fit-test. 
 +  * In Cura, set the ''Horizontal offset'' to a negative number (in mm) to make the model leaner in the horizontal plane. Set it to a positive number to make it fatter. Use small values like for example ''0.1mm''
 +  * Print the test piece and measure it with calipers.  
 +    * If the dimensions are different than the CAD model, adjust the horizontal offset.  
 +    * If the dimensions are the same as the CAD model, but it doesn't fit properly, adjust the clearance values in the CAD model. 
 +  * 
  • slicers/slicers.1596446395.txt.gz
  • Last modified: 2020/08/03 02:19
  • by formlab