Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
slicers:slicers [2020/08/03 02:18] – created formlab | slicers:slicers [2020/08/03 05:08] (current) – formlab | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Cura ===== | ===== Cura ===== | ||
- | === per model settings === | + | ==== Per model settings |
- | {{: | + | {{: |
Use different slicer settings in the volume of a selected object. | Use different slicer settings in the volume of a selected object. | ||
- | Example: use a more dense infill in a specified area | + | |
+ | **Example**: use a more dense infill in a specified area | ||
* Add the object you want to print. | * Add the object you want to print. | ||
* Add the object you want to define the dense infill with (a cube could work just fine). | * Add the object you want to define the dense infill with (a cube could work just fine). | ||
Line 17: | Line 18: | ||
* Bottom Layers: '' | * Bottom Layers: '' | ||
* Infill Density: the desired value for your print | * Infill Density: the desired value for your print | ||
- | {{: | + | {{: |
+ | When you're using Gradual Infill Steps in your main model, don't forget to add '' | ||
+ | ==== Calibrating for correct dimensions ==== | ||
+ | * Isolate a small piece of your model which you can use for a fit-test. | ||
+ | * In Cura, set the '' | ||
+ | * Print the test piece and measure it with calipers. | ||
+ | * If the dimensions are different than the CAD model, adjust the horizontal offset. | ||
+ | * If the dimensions are the same as the CAD model, but it doesn' | ||
+ | * |