Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
slicers:slicers [2020/08/03 02:19] – formlab | slicers:slicers [2020/08/03 02:30] – [Per model settings] formlab | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Cura ===== | ===== Cura ===== | ||
- | === per model settings === | + | ==== Per model settings |
{{: | {{: | ||
Use different slicer settings in the volume of a selected object. | Use different slicer settings in the volume of a selected object. | ||
Line 19: | Line 19: | ||
* Infill Density: the desired value for your print | * Infill Density: the desired value for your print | ||
{{: | {{: | ||
+ | |||
+ | When you're using Gradual Infill Steps in your main model, don't forget to add '' | ||