slicers:slicers

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
slicers:slicers [2020/08/03 02:18] – formlabslicers:slicers [2020/08/03 02:30] – [Per model settings] formlab
Line 3: Line 3:
 ===== Cura ===== ===== Cura =====
  
-=== per model settings ===+==== Per model settings ====
 {{:slicers:per_model_settings_-_result.png?600|}}\\ {{:slicers:per_model_settings_-_result.png?600|}}\\
 Use different slicer settings in the volume of a selected object. Use different slicer settings in the volume of a selected object.
-Example: use a more dense infill in a specified area+ 
 +**Example**: use a more dense infill in a specified area
   * Add the object you want to print.   * Add the object you want to print.
   * Add the object you want to define the dense infill with (a cube could work just fine).   * Add the object you want to define the dense infill with (a cube could work just fine).
Line 18: Line 19:
     * Infill Density: the desired value for your print     * Infill Density: the desired value for your print
 {{:slicers:per_model_settings_-_settings.png?600|}}\\ {{:slicers:per_model_settings_-_settings.png?600|}}\\
 +
 +When you're using Gradual Infill Steps in your main model, don't forget to add ''Gradual Infill Steps: 0'' to the per model settings
  
  
  
  • slicers/slicers.txt
  • Last modified: 2020/08/03 05:08
  • by formlab