slicers:slicers

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
Last revisionBoth sides next revision
slicers:slicers [2020/08/03 02:18] – created formlabslicers:slicers [2020/08/03 02:30] – [Per model settings] formlab
Line 3: Line 3:
 ===== Cura ===== ===== Cura =====
  
-=== per model settings === +==== Per model settings ==== 
-{{:slicers:per_model_settings_-_result.png?600|}}+{{:slicers:per_model_settings_-_result.png?600|}}\\
 Use different slicer settings in the volume of a selected object. Use different slicer settings in the volume of a selected object.
-Example: use a more dense infill in a specified area+ 
 +**Example**: use a more dense infill in a specified area
   * Add the object you want to print.   * Add the object you want to print.
   * Add the object you want to define the dense infill with (a cube could work just fine).   * Add the object you want to define the dense infill with (a cube could work just fine).
Line 17: Line 18:
     * Bottom Layers: ''0''     * Bottom Layers: ''0''
     * Infill Density: the desired value for your print     * Infill Density: the desired value for your print
-{{:slicers:per_model_settings_-_settings.png?600|}}+{{:slicers:per_model_settings_-_settings.png?600|}}\\ 
 + 
 +When you're using Gradual Infill Steps in your main model, don't forget to add ''Gradual Infill Steps: 0'' to the per model settings
  
  
  
  • slicers/slicers.txt
  • Last modified: 2020/08/03 05:08
  • by formlab