Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projet_cjp_660:projet_cjp_660 [2022/02/25 05:00] – formlab | projet_cjp_660:projet_cjp_660 [2022/09/30 02:01] (current) – [Pre print checks] formlab | ||
---|---|---|---|
Line 2: | Line 2: | ||
{{: | {{: | ||
+ | |||
+ | ===== 3D modelling workflow ===== | ||
+ | |||
+ | * [[projet_cjp_660: | ||
+ | |||
+ | |||
+ | Issue with lines on texture in 3D Print (not visible in Blender): https:// | ||
+ | - hmm.. texture was 2x2k. Try maybe a UV render with larger spaces between the islands? | ||
+ | |||
Line 8: | Line 17: | ||
* Check power status print-computer. No sleep or screen saver. | * Check power status print-computer. No sleep or screen saver. | ||
* Raise build plate (!) | * Raise build plate (!) | ||
+ | * Clean the parking caps. | ||
+ | * Clean the service station. | ||
+ | * Clean the spreader roller and scrapers. | ||
+ | * Clean the fast axis rails and carriage. | ||
+ | |||
==== Post print steps and cleaning ==== | ==== Post print steps and cleaning ==== | ||
- | * Leave print in build chamber for x minutes (LOOK UP DURATION) | + | * Leave print in build chamber for 2 hours to strengthen the glue. |
- | * Vacuum excess core material | + | * Vacuum excess core material. |
- | * Raise buildplate | + | * Raise buildplate. |
- | * Clean the debris separator grille | + | * Clean the debris separator grille. |
- | * Clean the parking caps | + | * Clean the parking caps. |
- | * Clean the service station | + | * Clean the service station. |
- | * Clean the spreader roller and scrapers | + | * Clean the spreader roller and scrapers. |
- | * Clean the fast axis rails and carriage | + | * Clean the fast axis rails and carriage. |
==== Cleaning print ==== | ==== Cleaning print ==== | ||
Line 78: | Line 92: | ||
---- | ---- | ||
- | |||
- | ===== 3D modelling workflow ===== | ||
- | |||
- | * [[projet_cjp_660: | ||
- | |||
- | |||
- | Issue with lines on texture in 3D Print (not visible in Blender): https:// | ||
- | - hmm.. texture was 2x2k. Try maybe a UV render with larger spaces between the islands? | ||