Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Openbuilds Acro ====== {{:openbuilds_acro:acro_1510_small_01.jpg|}}\\ Model Acro 1510 Max plotting area: 82 x 124cm Workflow:\\ Create vector image → convert to Gcode → Send to plotter ===== Getting started ===== **[[Workflow - how to plot]]** ===== References ===== [[https://cam.openbuilds.com/|Openbuilds G-code generator]] [[https://sameer.github.io/svg2gcode/|svg2gcode generator]] [[https://software.openbuilds.com/|Software]] The blackbox motion controller runs on GRBL (see [[https://reprap.org/wiki/G-code#G-commands|list of commands]]) openbuilds_acro/openbuilds_acro.txt Last modified: 2024/02/19 01:55by formlab