openbuilds_acro:openbuilds_acro

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
openbuilds_acro:openbuilds_acro [2024/02/05 03:27] – formlabopenbuilds_acro:openbuilds_acro [2024/02/19 01:55] (current) – [Openbuilds Acro] formlab
Line 4: Line 4:
 Model Acro 1510 Model Acro 1510
  
-[[https://cam.openbuilds.com/|Openbuilds G-code generator]]+Max plotting area: 82 x 124cm
  
 +Workflow:\\ 
 +Create vector image → convert to Gcode → Send to plotter
 +===== Getting started =====
 +**[[Workflow - how to plot]]**
 +
 +
 +===== References =====
 +[[https://cam.openbuilds.com/|Openbuilds G-code generator]]
 +[[https://sameer.github.io/svg2gcode/|svg2gcode generator]]
  
 [[https://software.openbuilds.com/|Software]] [[https://software.openbuilds.com/|Software]]
Line 11: Line 20:
 The blackbox motion controller runs on GRBL (see [[https://reprap.org/wiki/G-code#G-commands|list of commands]]) The blackbox motion controller runs on GRBL (see [[https://reprap.org/wiki/G-code#G-commands|list of commands]])
  
-**[[Workflow - how to plot]]**+
  
  
  • openbuilds_acro/openbuilds_acro.txt
  • Last modified: 2024/02/19 01:55
  • by formlab