lulzbot_taz_6:lulzbot_taz_6

This is an old revision of the document!


Lulzbot Taz 6

Max Build Volume: 280 x 280 x 250mm


Park Position (for use with the pause-at-height-script)
X = 290
Y = 280

  • The printer underextrudes after ±10 - 15 minutes.
  • Check your belt tension
  • Wipe down the smooth rods (no lubrication)
  • Blow out the fan/control box while powered down
  • Lubricate Z-lead screw
  • Check the set screws on the stepper motor pulleys and the small gear on the extruder, tighten if necessary. Use of a mild thread locking compound is acceptable.
  • Examine the threaded rod couplers. TAZ users should make sure the hose clamps are tight.
  • Verify that any frame screws are tight.
  • Check for software updates. Update Cura LulzBot Edition at LulzBot.com/Cura. Slic3r can be found at Slicer.org and Printrun can be found at Github.com/Kliment/Printrun.
  • lulzbot_taz_6/lulzbot_taz_6.1623929099.txt.gz
  • Last modified: 2021/06/17 04:24
  • by formlab