Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
lulzbot_taz_6:lulzbot_taz_6 [2020/05/25 02:49] – formlab | lulzbot_taz_6:lulzbot_taz_6 [2023/03/13 07:12] – [Pause before print] formlab | ||
---|---|---|---|
Line 14: | Line 14: | ||
Y = 280 | Y = 280 | ||
- | [[:How much does FDM printing cost?]] | + | * [[:How much does FDM printing cost?]] |
+ | * [[:Filament options]] | ||
+ | |||
+ | ===== Pause before print ===== | ||
+ | |||
+ | Insert after this line: '' | ||
+ | |||
+ | < | ||
+ | ; | ||
+ | ;added code by post processing | ||
+ | ;script: PauseAtHeightorLayer.py | ||
+ | ;current layer: 0 | ||
+ | ;current z: 0.200000 | ||
+ | ;pause_by: H | ||
+ | ; | ||
+ | M83 ;Set E relative | ||
+ | G1 Z5.000000 F300 | ||
+ | G1 X0.000000 Y258.000000 F9000 | ||
+ | G1 Z180 F300 | ||
+ | M84 E0 | ||
+ | M104 S180 ; standby temperature | ||
+ | M0 ; Do the actual pause | ||
+ | M109 S200 ; resume temperature | ||
+ | G1 Z5.000000 F300 | ||
+ | G1 X166.558000 Y96.693000 F9000 | ||
+ | M82 ;Set E absolute | ||
+ | G92 E0.000000 | ||
+ | </ | ||
+ | |||
+ | ===== Troubleshooting ===== | ||
+ | * The printer underextrudes after ±10 - 15 minutes. | ||
+ | * This could be [[https:// | ||
===== Maintenance ===== | ===== Maintenance ===== | ||
Line 34: | Line 65: | ||
* Verify that any frame screws are tight. | * Verify that any frame screws are tight. | ||
* Check for software updates. Update Cura LulzBot Edition at [[https:// | * Check for software updates. Update Cura LulzBot Edition at [[https:// | ||
- | + |