isel_icv4030:isel_icv4030

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
isel_icv4030:isel_icv4030 [2021/01/26 01:44] formlabisel_icv4030:isel_icv4030 [2023/05/10 05:55] (current) – [Available material] formlab
Line 9: Line 9:
   * [[Milling PCB's]]   * [[Milling PCB's]]
   * [[isel_icv4030:Engraving large pockets]]   * [[isel_icv4030:Engraving large pockets]]
 +  * [[isel_icv4030:Engraving detailed images]]
  
 ---- ----
  
-=== What does it cost? ===+===== What does it cost? =====
  
   ( item cost * item count or item length (in centimeters) * material multiplier )   ( item cost * item count or item length (in centimeters) * material multiplier )
   +   +
   ( machine time (hours) * machine multiplier )   ( machine time (hours) * machine multiplier )
 +
 + * item count or item length: sheet items are counted per piece. Rectangular or square bars are counted per centimeter
 +  * material multiplier: item cost * item count * 2 (included in the table below)
 +  * machine time multiplier:
 +    * For projects under 2 hours: €7 per hour
 +    * For projects over 2 hours and under 5 hours: €6,5 per hour
 +    * For projects over 5 hours: €6 per hour
 +
 +----
 +
 +{{:isel_icv4030:materials-aluminum.jpg|}}
 +===== Available material =====
 +
 +^ Material ^ Dimensions ^ Cost ^
 +| Aluminum plate | 280x140x8mm | €9,20 per piece |
 +| Aluminum plate | 300x260x5mm | €10,60 per piece |
 +| square bar | 20x20mm | €0,20 per cm |
 +| square bar | 40x40mm | €0,40 per cm |
 +| square bar | 60x60mm | €0,80 per cm |
 +| rectangular bar | 80x30mm | €0,80 per cm |
 +| rectangular bar | 80x40mm | €1,00 per cm |
 +| rectangular bar | 150x15mm | €0,80 per cm |
 +| rectangular bar | 200x10mm | €0,60 per cm |
 +| rectangular bar | 200x20mm | €1,20 per cm |
 +
 +----
 +
 +=== Aluminum ===
 +Tested alloy: 6082 / ALMgSi1
 +[[https://testas.be/|Testas]]: [[https://mcbgroup.eu/app/uploads/sites/2/2018/01/DS31-6082-gewalst.pdf|data sheet]]
 +
 +=== Messing ===
 +Tested alloy: CuZn 37
 +
 +===== Milling tips =====
 +  * Foam
 +    * single flute
 +    * down cut
 +    * 3000mm/min and 18-24,000rpm depending on bit diameter
 +    * use conventional milling
  
  • isel_icv4030/isel_icv4030.1611654258.txt.gz
  • Last modified: 2021/01/26 01:44
  • by formlab