Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
isel_icv4030:isel_icv4030 [2021/01/26 01:45] – formlab | isel_icv4030:isel_icv4030 [2023/05/10 05:52] – [What does it cost?] formlab | ||
---|---|---|---|
Line 9: | Line 9: | ||
* [[Milling PCB' | * [[Milling PCB' | ||
* [[isel_icv4030: | * [[isel_icv4030: | ||
+ | * [[isel_icv4030: | ||
---- | ---- | ||
- | === What does it cost? === | + | ===== What does it cost? ===== |
( item cost * item count or item length (in centimeters) * material multiplier ) | ( item cost * item count or item length (in centimeters) * material multiplier ) | ||
Line 20: | Line 20: | ||
* item count or item length: sheet items are counted per piece. Rectangular or square bars are counted per centimeter | * item count or item length: sheet items are counted per piece. Rectangular or square bars are counted per centimeter | ||
- | * material multiplier: 50%: item cost * item count * 1,5 (included in the table below) | + | * material multiplier: item cost * item count * 2 (included in the table below) |
- | * machine multiplier: €5 per hour | + | * machine |
+ | * For projects under 2 hours: €7 per hour | ||
+ | * For projects over 2 hours and under 5 hours: €6,5 per hour | ||
+ | * For projects over 5 hours: €6 per hour | ||
---- | ---- | ||
{{: | {{: | ||
- | ==== Available material ==== | + | ===== Available material |
^ Material ^ Dimensions ^ Cost ^ | ^ Material ^ Dimensions ^ Cost ^ | ||
Line 42: | Line 45: | ||
---- | ---- | ||
- | [[https:// | + | === Aluminum === |
+ | Tested alloy: 6082 / ALMgSi1 | ||
+ | [[https:// | ||
+ | |||
+ | === Messing === | ||
+ | Tested alloy: CuZn 37 | ||
+ | |||
+ | ===== Milling tips ===== | ||
+ | * Foam | ||
+ | * single flute | ||
+ | * down cut | ||
+ | * 3000mm/min and 18-24, | ||
+ | * use conventional milling |