hyrel:hyrel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
hyrel:hyrel [2020/10/12 06:26] – [Tests] formlabhyrel:hyrel [2021/01/26 01:38] (current) – [Hyrel] formlab
Line 38: Line 38:
   * [[hyrel:VOL-25]] - For heated emulsifiables   * [[hyrel:VOL-25]] - For heated emulsifiables
   * [[hyrel:MK1-250]] - for plastic filament   * [[hyrel:MK1-250]] - for plastic filament
 +  * [[hyrel:Luer-tips]] - needles for the Emo-25 head
  
  
Line 70: Line 71:
   * Slower speed helps (no tearing), but lines are a little crumbly at ''1.5w, 0.5z, 5f 0pct''?   * Slower speed helps (no tearing), but lines are a little crumbly at ''1.5w, 0.5z, 5f 0pct''?
   * Material Flow Rate Multiplier (in the Head-control section). Adjustments are sent to print head when pressing enter, or when clicking outside the number box (setting the cursor in another number box). This setting is thus live and overrides the Slic3r material flow parameter.   * Material Flow Rate Multiplier (in the Head-control section). Adjustments are sent to print head when pressing enter, or when clicking outside the number box (setting the cursor in another number box). This setting is thus live and overrides the Slic3r material flow parameter.
 +  * Head Control - Nozzle size overrides the nozzle size set in Slic3r. 
  
  
Line 96: Line 98:
     * 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold)     * 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold)
   * Try printing again with a heated bed (20°   * Try printing again with a heated bed (20°
-  * Unrelated to this problem: I should try out more agressive prime and unprime settings. (Definite influence).+  * Unrelated to this problem: I should try out more aggressive prime and unprime settings. (Definite influence).
  
 +
 +
 +==== Issues ====
 +  * Printer sometimes doesn't wait until desired temperature is reached.
 +  * After stopping the print (Kill function), **reset Z-zero**
 +  * It seems that Repetrel doesn't do accelerations? Why is that?
 +
 +
 +
 +==== Random knowledge ====
 +  * ''M756'': S[layer thickness in mm] - for flow calculation
 +  * ''M221'': sets flow rate
 +  * ''M104'': print temperature
 +  * Davo 01/10/2015
 +    * **Reset**: will reboot the 407 motion controller
 +    * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater
 +    * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet
 +  * If you hear tics in a regular or random pattern, chances are you're printing with 'Spiral mode' selected. The tics are generated by the the Z-axis motor.
  • hyrel/hyrel.1602509170.txt.gz
  • Last modified: 2020/10/12 06:26
  • by formlab