This is an old revision of the document!

Modular system with both FDM and extrusion of emulsifiable materials (a.k.a a paste or gel printer).

  • Max Build Volume: 225 x 200 x 200mm

  • Clean cylinders after each use! Not doing so will ruin them.
  • While it is possible to print with food products, we do not recommend it, due to the difficulty of insuring sanitary conditions.
  • Official Repetrel info page: http://hyrel3d.net/wiki/index.php/Repetrel
    • Check Prime & Unprime sections
  • Head panel overrides (??)
    • Nozzle Ø: This should be set correctly (test to make sure it overrides the slic3r profile)
    • Layer Z in mm: this is not important, as it is overridden by G-code
  • Emo-25 - For emulsifiables at room temperature
  • VOL-25 - For heated emulsifiables
  • MK1-250 - for plastic filament
  • hyrel/hyrel.1602067846.txt.gz
  • Last modified: 2020/10/07 03:50
  • by formlab