hyrel:hyrel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
hyrel:hyrel [2020/10/12 07:55] – [Tool-head specific info] formlabhyrel:hyrel [2021/01/26 01:38] (current) – [Hyrel] formlab
Line 105: Line 105:
   * Printer sometimes doesn't wait until desired temperature is reached.   * Printer sometimes doesn't wait until desired temperature is reached.
   * After stopping the print (Kill function), **reset Z-zero**   * After stopping the print (Kill function), **reset Z-zero**
 +  * It seems that Repetrel doesn't do accelerations? Why is that?
  
  
Line 116: Line 117:
     * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater     * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater
     * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet     * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet
 +  * If you hear tics in a regular or random pattern, chances are you're printing with 'Spiral mode' selected. The tics are generated by the the Z-axis motor.
  • hyrel/hyrel.txt
  • Last modified: 2021/01/26 01:38
  • by formlab