hyrel:hyrel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
hyrel:hyrel [2020/10/12 07:55] – [Tool-head specific info] formlabhyrel:hyrel [2021/01/26 01:38] – [Hyrel] formlab
Line 5: Line 5:
  
   * Max Build Volume: ''225 x 200 x 200mm''   * Max Build Volume: ''225 x 200 x 200mm''
 +a
 ==== Tutorial ==== ==== Tutorial ====
   * [[hyrel:Your first print]]   * [[hyrel:Your first print]]
Line 105: Line 105:
   * Printer sometimes doesn't wait until desired temperature is reached.   * Printer sometimes doesn't wait until desired temperature is reached.
   * After stopping the print (Kill function), **reset Z-zero**   * After stopping the print (Kill function), **reset Z-zero**
 +  * It seems that Repetrel doesn't do accelerations? Why is that?
  
  
Line 116: Line 117:
     * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater     * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater
     * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet     * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet
 +  * If you hear tics in a regular or random pattern, chances are you're printing with 'Spiral mode' selected. The tics are generated by the the Z-axis motor.
  • hyrel/hyrel.txt
  • Last modified: 2021/01/26 01:38
  • by formlab