Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
autodesk_ember:autodesk_ember [2021/04/15 08:31] – [Calibration] formlab | autodesk_ember:autodesk_ember [2021/04/15 08:32] (current) – [Pre-print] formlab | ||
---|---|---|---|
Line 98: | Line 98: | ||
* The resin tray rotates without any jamming or skipping of steps | * The resin tray rotates without any jamming or skipping of steps | ||
- | You can skip the calibration routine when the build head and resin tray havent been moved. | + | Calibration is only necessary after |
+ | * a failed print | ||
+ | * a changed | ||
+ | * a changed build head | ||