Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
autodesk_ember:autodesk_ember [2021/04/15 08:30] – formlab | autodesk_ember:autodesk_ember [2021/04/15 08:32] (current) – [Pre-print] formlab | ||
---|---|---|---|
Line 98: | Line 98: | ||
* The resin tray rotates without any jamming or skipping of steps | * The resin tray rotates without any jamming or skipping of steps | ||
- | You can skip the calibration routine when the build head and resin tray havent been moved. | + | Calibration is only necessary after |
+ | * a failed print | ||
+ | * a changed | ||
+ | * a changed build head | ||
Line 338: | Line 341: | ||
* Wear goggles to protect your eyes from accidental splashes of resin | * Wear goggles to protect your eyes from accidental splashes of resin | ||
* Wear nitrile gloves - (throw away after use, or clean them thoroughly with alcohol) | * Wear nitrile gloves - (throw away after use, or clean them thoroughly with alcohol) | ||
- | |||
- | ==== Calibration ==== | ||
- | |||
- | Necessary after | ||
- | * a failed print | ||
- | * a changed resin tray | ||
- | * a changed build head | ||