autodesk_ember:autodesk_ember

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
autodesk_ember:autodesk_ember [2021/04/15 08:28] – [Pre-print] formlabautodesk_ember:autodesk_ember [2021/04/15 08:32] (current) – [Pre-print] formlab
Line 43: Line 43:
  
 === How To Add Resin === === How To Add Resin ===
-** **Resin should only be in the tray for the duration of the printing time. When the print is complete, the resin should be poured out of the tray.** This will help to extend the life of your resin tray, and will reduce the change of damage to your printer as a result of resin leaking from a damaged tray into Ember's interior.+  * **Resin should only be in the tray for the duration of the printing time. When the print is complete, the resin should be poured out of the tray.** This will help to extend the life of your resin tray, and will reduce the change of damage to your printer as a result of resin leaking from a damaged tray into Ember's interior.
   * Never store trays full of resin in Ember's build chamber when Ember is not in use.     * Never store trays full of resin in Ember's build chamber when Ember is not in use.  
   * Before removing the resin tray, remember to always remove the build head, to prevent resin from dripping from the build head onto the window of the projector.   * Before removing the resin tray, remember to always remove the build head, to prevent resin from dripping from the build head onto the window of the projector.
Line 98: Line 98:
   * The resin tray rotates without any jamming or skipping of steps   * The resin tray rotates without any jamming or skipping of steps
  
-You can skip the calibration routine when the build head and resin tray havent been moved.+Calibration is only necessary after  
 +  * a failed print 
 +  * a changed resin tray 
 +  * a changed build head
  
  
Line 338: Line 341:
   * Wear goggles to protect your eyes from accidental splashes of resin   * Wear goggles to protect your eyes from accidental splashes of resin
   * Wear nitrile gloves - (throw away after use, or clean them thoroughly with alcohol)   * Wear nitrile gloves - (throw away after use, or clean them thoroughly with alcohol)
- 
-==== Calibration ==== 
- 
-Necessary after  
-  * a failed print 
-  * a changed resin tray 
-  * a changed build head 
  
  
  • autodesk_ember/autodesk_ember.1618500483.txt.gz
  • Last modified: 2021/04/15 08:28
  • by formlab