Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| autodesk_ember:autodesk_ember [2021/04/15 08:28] – [Pre-print] formlab | autodesk_ember:autodesk_ember [2021/04/15 08:31] – [Calibration] formlab | ||
|---|---|---|---|
| Line 43: | Line 43: | ||
| === How To Add Resin === | === How To Add Resin === | ||
| - | ** **Resin should only be in the tray for the duration of the printing time. When the print is complete, the resin should be poured out of the tray.** This will help to extend the life of your resin tray, and will reduce the change of damage to your printer as a result of resin leaking from a damaged tray into Ember' | + | |
| * Never store trays full of resin in Ember' | * Never store trays full of resin in Ember' | ||
| * Before removing the resin tray, remember to always remove the build head, to prevent resin from dripping from the build head onto the window of the projector. | * Before removing the resin tray, remember to always remove the build head, to prevent resin from dripping from the build head onto the window of the projector. | ||
| Line 338: | Line 338: | ||
| * Wear goggles to protect your eyes from accidental splashes of resin | * Wear goggles to protect your eyes from accidental splashes of resin | ||
| * Wear nitrile gloves - (throw away after use, or clean them thoroughly with alcohol) | * Wear nitrile gloves - (throw away after use, or clean them thoroughly with alcohol) | ||
| - | |||
| - | ==== Calibration ==== | ||
| - | |||
| - | Necessary after | ||
| - | * a failed print | ||
| - | * a changed resin tray | ||
| - | * a changed build head | ||