====== Add the Stacker printer to Cura ======

{{:add_the_stacker_printer_to_cura:add_stacker_to_cura_01_wiki.jpg?nolink&600|}}\\
This guide works for Cura v4.0.0

{{:add_the_stacker_printer_to_cura:add_stacker_to_cura_02_wiki.jpg?nolink&600|}}\\
If this is the first time you open Cura, an 'add 3D printer' dialog pops up.\\
Skip to the next image.
 

If you have used Cura with other 3D printers, do the following steps:\\
  * In the left top, click on the name of the currently selected 3D printer. 
  * On the bottom of the pop up menu, select 'Add printer'

{{:add_the_stacker_printer_to_cura:add_stacker_to_cura_03_wiki.jpg?nolink&600|}}\\
Select Custom FFF printer, and give it a name

{{:add_the_stacker_printer_to_cura:add_stacker_to_cura_04_wiki.jpg?nolink&600|}}\\
In the Printer-tab, copy all values in the red border.

 

Copy this code and paste it in the Start G-code field (green):\\
<code>
; Formlab 
; Stacker Start G-code


G28 ;Home
G1 Z2.0 F6000 ;Move the platform down 2mm
G0 F3600 X0 Y10 ; Move print head close to edge of print bed


G92 E0
G1 F100 E25
G92 E0


G0 F3600 X0 Y25 ; Move print head close to edge of print bed
G92 X0 Y0 Z2.0 ; Set current location as new 0, 0
</code>

\\
Copy this code and paste it in the End G-code field (Blue):\\
<code>
; Formlab
; Stacker End G-code

M104 S0
M140 S0

G91 ;Relative movement
G0 F3600 X8.0 Z0.5 E-4.5 ;Wiping+material retraction
G0 F3600 Z1.5 E4.5 ;Compensation for the retraction
G90 ;Disable relative movement

G92 E1
G1 E-1 F300

G28 X0 Y0 ;home named axes
M84 ;disable steppers
</code>

{{:add_the_stacker_printer_to_cura:add_stacker_to_cura_05_wiki.jpg?nolink&600|}}\\
In tab 'Extruder 1', copy the values for Nozzle size and filament diameter.

Click close.

 
To add the printer profile in cura, continue [[stacker_s4:add_printer_profile_for_the_stacker_printer_in_cura|here]]