Instructions

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Ultimaker S5 ======
{{:ultimaker_s5:ultimaker-s5.jpg?nolink&200|}}


  * Max Build Volume: ''330 x 240 x 300mm''
  * [[:Filament options]]


[[https://www.formlab.schoolofarts.be/pricing|How much does FDM printing cost?]]


----

===== Maintenance =====
==== Every 2 months ====
  * [[https://ultimaker.com/en/resources/52604-clean-the-printer|Clean printer]]
    * wash build plate with warm water
    * heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel)
    * clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube.
  * [[https://ultimaker.com/en/resources/52605-lubricate-the-axles|Lubricate axles]]
    * clean all smooth axles with a paper towel
    * one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute.


==== Every 6 months ====
  * [[https://ultimaker.com/en/resources/52606-check-for-play-on-the-axles|Check for play on axles]]
  * [[https://ultimaker.com/en/resources/52607-check-the-tension-of-the-short-belts|Check tension of short belts]]
  * [[https://ultimaker.com/en/resources/52609-check-for-debris-in-the-front-fan-of-the-print-head|Check for residue in front fan of print head]]
  * [[https://ultimaker.com/en/resources/52611-check-the-quality-of-the-nozzle-cover|Check quality of silicone nozzle cover]]
  * [[https://ultimaker.com/en/resources/52614-clean-the-print-cores|Clean print cores]]
  * [[https://ultimaker.com/en/resources/52613-clean-the-feeders|Clean the feeders]]
  * [[https://ultimaker.com/en/resources/52612-lubricate-the-z-screw-of-the-z-motor|Lubricate lead screw Z motor]]
==== Yearly ====

  * [[https://ultimaker.com/en/resources/52615-lubricate-the-feeder-gear|Lubricate the feeder gear]]
  * [[https://ultimaker.com/en/resources/52616-replace-the-bowden-tubes|Replace Bowden tubes]]
  * [[https://ultimaker.com/en/resources/52617-clean-the-system-fans|Clean the system fans]]
  * [[https://ultimaker.com/en/resources/52618-lubricate-the-hinges|Lubricate the hinges]]