Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| ultimaker_original:maintenance [2020/01/08 07:45] – formlab | ultimaker_original:maintenance [2020/01/08 07:48] (current) – formlab | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| * level bed | * level bed | ||
| * clean glass print bed with warm water | * clean glass print bed with warm water | ||
| - | * clean and lubricate axles | + | * clean and lubricate axles. Only add green grease to the lead screw |
| - | * hot and cold nozzle | + | * [[https:// |
| + | * Check feeder and clean if necessary | ||
| Less often | Less often | ||
| Line 12: | Line 13: | ||
| * check that print head is parallel with the other axles. Use the wooden helper pieces. | * check that print head is parallel with the other axles. Use the wooden helper pieces. | ||
| * Change heat brake plastic thingy | * Change heat brake plastic thingy | ||
| + | * replace Bowden tube | ||