ultimaker_original:maintenance

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
ultimaker_original:maintenance [2020/01/08 07:43] – formlabultimaker_original:maintenance [2020/01/08 07:48] (current) – formlab
Line 4: Line 4:
   * level bed   * level bed
   * clean glass print bed with warm water   * clean glass print bed with warm water
-  * clean and lubricate axles+  * clean and lubricate axles. Only add green grease to the lead screw 
 +  * [[https://ultimaker.com/en/resources/23132-clean-the-print-cores|Clean nozzle]] 
 +  * Check feeder and clean if necessary
  
 Less often Less often
-  * check for tension on belts going to the motors. Retighten if necessary.+  * [[https://ultimaker.com/en/resources/39664-check-the-tension-of-the-short-belts|Check tension short belts]]
   * Check for play on the axles: **Don't follow the regular maintenance here**. On UM2 and above the axles should not move lengthwise, but there are no pulleys blocking the axles from moving. There is some play in the wooden end caps. Maybe put some spacers in if necessary.   * Check for play on the axles: **Don't follow the regular maintenance here**. On UM2 and above the axles should not move lengthwise, but there are no pulleys blocking the axles from moving. There is some play in the wooden end caps. Maybe put some spacers in if necessary.
   * check that print head is parallel with the other axles. Use the wooden helper pieces.   * check that print head is parallel with the other axles. Use the wooden helper pieces.
 +  * Change heat brake plastic thingy
 +  * replace Bowden tube
  • ultimaker_original/maintenance.1578498204.txt.gz
  • Last modified: 2020/01/08 07:43
  • by formlab