Differences

This shows you the differences between two versions of the page.

--- slicers:slicers [2020/08/03 02:30] – formlab
+++ slicers:slicers [2024/05/13 00:42] (current) – removed formlab
@@ Line 1: / Line 1: @@
-====== Slicers ======
-===== Cura =====
-==== Per model settings ====
-{{:slicers:per_model_settings_-_result.png?600|}}\\
-Use different slicer settings in the volume of a selected object.
-**Example**: use a more dense infill in a specified area
-  * Add the object you want to print.
-  * Add the object you want to define the dense infill with (a cube could work just fine).
-  * Change the size and position of the second object so it overlaps the first object at the desired location.
-  * Select the second object. In the side bar, go to ''per model settings'' and select ''Modify settings for overlaps''.
-  * select ''infill mesh only''
-  * select the following settings:
-    * Wall line count: ''0''
-    * Top Layers: ''0''
-    * Bottom Layers: ''0''
-    * Infill Density: the desired value for your print
-{{:slicers:per_model_settings_-_settings.png?600|}}\\
-When you're using Gradual Infill Steps in your main model, don't forget to add Gradual Infill Steps: ''0'' to the per model settings