isel_icv4030:milling_pcb_s_v2

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
isel_icv4030:milling_pcb_s_v2 [2025/08/18 02:43] – formlabisel_icv4030:milling_pcb_s_v2 [2025/08/18 02:48] (current) – [Single layered PCB] formlab
Line 9: Line 9:
   * Use 1mm wide traces   * Use 1mm wide traces
   * Try to enlarge the pads as much as possible while respecting the margin. You can speed up the process for similar components by changing 1 pad, then choose ''Copy pad properties to default'' from the context menu. Then set the selection filter (right bottom window) to only pads. Box select to select all wanted pads choose ''Paste default pad properties to selected''.   * Try to enlarge the pads as much as possible while respecting the margin. You can speed up the process for similar components by changing 1 pad, then choose ''Copy pad properties to default'' from the context menu. Then set the selection filter (right bottom window) to only pads. Box select to select all wanted pads choose ''Paste default pad properties to selected''.
 +  * Don't draw GND tracks, as you'll use a ground plane (copper pour) with the option 'fill zone'. This prevents unnecessary overlapping track geometry in Freecad & Rhino.
  
 Save the Kicad project. Save the Kicad project.
  • isel_icv4030/milling_pcb_s_v2.txt
  • Last modified: 2025/08/18 02:48
  • by formlab