hyrel:hyrel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
hyrel:hyrel [2020/10/12 06:50] – [Tests] formlabhyrel:hyrel [2021/01/26 01:38] (current) – [Hyrel] formlab
Line 38: Line 38:
   * [[hyrel:VOL-25]] - For heated emulsifiables   * [[hyrel:VOL-25]] - For heated emulsifiables
   * [[hyrel:MK1-250]] - for plastic filament   * [[hyrel:MK1-250]] - for plastic filament
 +  * [[hyrel:Luer-tips]] - needles for the Emo-25 head
  
  
Line 104: Line 105:
   * Printer sometimes doesn't wait until desired temperature is reached.   * Printer sometimes doesn't wait until desired temperature is reached.
   * After stopping the print (Kill function), **reset Z-zero**   * After stopping the print (Kill function), **reset Z-zero**
 +  * It seems that Repetrel doesn't do accelerations? Why is that?
  
  
Line 111: Line 113:
   * ''M221'': sets flow rate   * ''M221'': sets flow rate
   * ''M104'': print temperature   * ''M104'': print temperature
 +  * Davo 01/10/2015
 +    * **Reset**: will reboot the 407 motion controller
 +    * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater
 +    * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet
 +  * If you hear tics in a regular or random pattern, chances are you're printing with 'Spiral mode' selected. The tics are generated by the the Z-axis motor.
  • hyrel/hyrel.1602510606.txt.gz
  • Last modified: 2020/10/12 06:50
  • by formlab