Differences

This shows you the differences between two versions of the page.

--- hyrel:hyrel [2020/10/12 06:29] – [Tests] formlab
+++ hyrel:hyrel [2021/01/26 01:38] (current) – [Hyrel] formlab
@@ Line 38: / Line 38: @@
   * [[hyrel:VOL-25]] - For heated emulsifiables
   * [[hyrel:MK1-250]] - for plastic filament
+  * [[hyrel:Luer-tips]] - needles for the Emo-25 head
@@ Line 97: / Line 98: @@
     * 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold)
   * Try printing again with a heated bed (20°
-  * Unrelated to this problem: I should try out more agressive prime and unprime settings. (Definite influence).
+  * Unrelated to this problem: I should try out more aggressive prime and unprime settings. (Definite influence).
+==== Issues ====
+  * Printer sometimes doesn't wait until desired temperature is reached.
+  * After stopping the print (Kill function), **reset Z-zero**
+  * It seems that Repetrel doesn't do accelerations? Why is that?
+==== Random knowledge ====
+  * ''M756'': S[layer thickness in mm] - for flow calculation
+  * ''M221'': sets flow rate
+  * ''M104'': print temperature
+  * Davo 01/10/2015
+    * **Reset**: will reboot the 407 motion controller
+    * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater
+    * **Respond**: was intended to be used to resume after a pause, but I don't know if it's enabled yet
+  * If you hear tics in a regular or random pattern, chances are you're printing with 'Spiral mode' selected. The tics are generated by the the Z-axis motor.