Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projet_mjp_3600:projet_mjp_3600 [2020/07/14 03:31] – [How much does it cost?] formlab | projet_mjp_3600:projet_mjp_3600 [2020/09/09 01:19] – formlab | ||
---|---|---|---|
Line 8: | Line 8: | ||
---- | ---- | ||
- | ===== How much does it cost? ===== | + | === How much does it cost? === |
< | < | ||
( build material cost + support material cost ) * material multiplier ) | ( build material cost + support material cost ) * material multiplier ) | ||
+ | + | ||
- | ( machine time (in hours) * machine time cost ) | + | ( machine time (in hours) * machine time multiplier |
</ | </ | ||
Line 25: | Line 25: | ||
* A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | ||
- | Post production | + | === Post production |
* Degrease object with IPA to increase adhesion for paint | * Degrease object with IPA to increase adhesion for paint | ||
* Use a primer for UV protection | * Use a primer for UV protection | ||
* Spray paint | * Spray paint | ||
* Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) | * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) |