Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| projet_mjp_3600:projet_mjp_3600 [2020/07/14 03:31] – [How much does it cost?] formlab | projet_mjp_3600:projet_mjp_3600 [2020/07/14 03:32] – [How much does it cost?] formlab | ||
|---|---|---|---|
| Line 25: | Line 25: | ||
| * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | ||
| - | Post production | + | === Post production |
| * Degrease object with IPA to increase adhesion for paint | * Degrease object with IPA to increase adhesion for paint | ||
| * Use a primer for UV protection | * Use a primer for UV protection | ||
| * Spray paint | * Spray paint | ||
| * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) | * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) | ||