Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ur10_robot_arm:ur10_robot_arm [2020/08/04 02:50] – [Physicial setup] formlab | ur10_robot_arm:ur10_robot_arm [2020/08/27 05:09] – [Pen plotter attachment] formlab | ||
---|---|---|---|
Line 9: | Line 9: | ||
===== future tool heads ===== | ===== future tool heads ===== | ||
* 3D scanner tool head | * 3D scanner tool head | ||
- | * | ||
- | ===== Brush attachment ===== | ||
+ | ===== Broom handle attachment ===== | ||
+ | {{: | ||
+ | {{: | ||
===== 3D print attachment ===== | ===== 3D print attachment ===== | ||
In development | In development | ||
+ | {{: | ||
===== Pen plotter attachment ===== | ===== Pen plotter attachment ===== | ||
+ | {{: | ||
+ | Used by [[http:// | ||
===== Webcam attachment ===== | ===== Webcam attachment ===== | ||
+ | {{: | ||
+ | {{: | ||
===== DSLR attachment ===== | ===== DSLR attachment ===== | ||
===== Hole drilling attachment ===== | ===== Hole drilling attachment ===== | ||
+ | {{: | ||
{{: | {{: | ||
- | This tool head was made to drill a grid of almost 500 holes into the base plate of the thermoform | + | This tool head turns the robot into an automated hole drilling |
- | ==== Physicial setup ==== | + | Based on [[https:// |
- | | + | |
- | | + | The 3D printed part attaches to a [[https:// |
- | The Dremel is strapped | + | |
+ | Download the 3D files {{ : | ||
+ | Attach the clamps | ||
+ | Attach the largest part to the tool changer | ||
+ | |||
+ | |||
+ | === Applications === | ||
+ | |||
+ | * [[: | ||