ultimaker_3_extended:ultimaker_3_extended

This is an old revision of the document!


Ultimaker 3 Extended

    • wash build plate with warm water
    • heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel)
    • clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube.
    • clean all smooth axles with a paper towel
    • one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute.
  • ultimaker_3_extended/ultimaker_3_extended.1569246884.txt.gz
  • Last modified: 2019/09/23 06:54
  • by formlab