ultimaker_3_extended:ultimaker_3_extended

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
ultimaker_3_extended:ultimaker_3_extended [2019/06/04 01:48] – created formlabultimaker_3_extended:ultimaker_3_extended [2020/06/23 04:11] (current) formlab
Line 1: Line 1:
 ====== Ultimaker 3 Extended ====== ====== Ultimaker 3 Extended ======
-{{:ultimaker_3_extended:ultimaker_3_extended.png?nolink|}}+{{:ultimaker_3_extended:ultimaker_3_extended.png?nolink&200|}} 
 + 
 + 
 +  * Max Build Volume: ''215 x 215 x 300mm'' 
 +  * [[:Filament options]] 
 + 
 +[[:How much does FDM printing cost?]] 
 + 
 +---- 
 + 
 +===== Maintenance ===== 
 +==== Every 2 months ==== 
 +  * [[https://ultimaker.com/en/resources/23131-clean-the-printer|Clean printer]] 
 +    * wash build plate with warm water 
 +    * heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel) 
 +    * clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube. 
 +  * [[https://ultimaker.com/en/resources/23130-lubricate-the-axles|Lubricate axles]]  
 +      * clean all smooth axles with a paper towel 
 +      * one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute. 
 + 
 + 
 +==== Every 6 months ==== 
 +  * [[https://ultimaker.com/en/resources/52500-check-for-play-on-axles|Check for play on axles]] 
 +      * [[https://ultimaker.com/en/resources/50871-check-for-play-on-axles|calibrate axles if play detected]] 
 +  * [[https://ultimaker.com/en/resources/39664-check-the-tension-of-the-short-belts|Check tension of short belts]] 
 +  * [[https://ultimaker.com/en/resources/50869-check-for-residue-in-the-front-fan-of-the-print-head|Check for residue in front fan of print head]] 
 +  * [[https://ultimaker.com/en/resources/52502-check-the-quality-of-the-silicone-nozzle-cover|Check quality of silicone nozzle cover]] 
 +  * [[https://ultimaker.com/en/resources/23132-clean-the-print-cores|Clean print cores]] 
 +  * [[https://ultimaker.com/en/resources/52503-lubricate-the-lead-screw-of-the-z-motor|Lubricate lead screw Z motor]] 
 +==== Yearly ==== 
 + 
 +  * [[https://ultimaker.com/en/resources/52504-clean-the-feeders|Clean feeders]] 
 +  * [[https://ultimaker.com/en/resources/52505-replace-the-bowden-tubes|Replace Bowden tubes]]
  • ultimaker_3_extended/ultimaker_3_extended.1559638099.txt.gz
  • Last modified: 2019/06/04 01:48
  • by formlab