Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projet_mjp_3600:projet_mjp_3600 [2019/06/04 01:25] – formlab | projet_mjp_3600:projet_mjp_3600 [2021/01/26 01:46] (current) – formlab | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Projet MJP 3600 ====== | ====== Projet MJP 3600 ====== | ||
- | {{: | + | {{: |
+ | |||
+ | Multijetting 3D printer | ||
+ | |||
+ | * Max Build Volume: '' | ||
+ | |||
+ | ---- | ||
+ | |||
+ | === How much does it cost? === | ||
+ | |||
+ | |||
+ | ( build material cost + support material cost ) * material multiplier ) | ||
+ | + | ||
+ | ( machine time (in hours) * machine time cost ) | ||
+ | |||
+ | * Build material cost: €515,70 per 2Kg | ||
+ | * Support material cost: €279,72 per 2Kg | ||
+ | * Material multiplier: 10% (build and support material * 1,1) | ||
+ | * Machine time cost: €0,55 per hour | ||
+ | |||
+ | |||
+ | === Design constraints === | ||
+ | * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material | ||
+ | |||
+ | === Post production === | ||
+ | * Degrease object with IPA to increase adhesion for paint | ||
+ | * Use a primer for UV protection | ||
+ | * Spray paint | ||
+ | * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental) |