projet_mjp_3600:projet_mjp_3600

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
projet_mjp_3600:projet_mjp_3600 [2020/07/14 03:31] – [How much does it cost?] formlabprojet_mjp_3600:projet_mjp_3600 [2020/09/09 01:19] formlab
Line 8: Line 8:
 ---- ----
  
-===== How much does it cost? =====+=== How much does it cost? ===
  
 <code> <code>
 ( build material cost + support material cost ) * material multiplier ) ( build material cost + support material cost ) * material multiplier )
   +   +
-( machine time (in hours) * machine time cost )+( machine time (in hours) * machine time multiplier )
 </code> </code>
  
Line 25: Line 25:
   * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material   * A hollow model needs a hole for the support material to drain out. Without a hole, the software will fill the space with building material
  
-Post production+=== Post production ===
   * Degrease object with IPA to increase adhesion for paint   * Degrease object with IPA to increase adhesion for paint
   * Use a primer for UV protection   * Use a primer for UV protection
   * Spray paint   * Spray paint
   * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental)   * Colouring the volume of the object: immerse into a mixture of acetone (30%), water (70%) and fabric paint (experimental)
  • projet_mjp_3600/projet_mjp_3600.txt
  • Last modified: 2021/01/26 01:46
  • by formlab