Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
other:other [2021/06/24 06:59] – formlab | other:other [2024/05/13 00:57] (current) – [Website] formlab | ||
---|---|---|---|
Line 7: | Line 7: | ||
* [[other:3D printing a single line]] | * [[other:3D printing a single line]] | ||
* [[https:// | * [[https:// | ||
+ | * [[other: | ||
+ | |||
+ | ===== Web-Print ===== | ||
+ | |||
+ | * [[https:// | ||
+ | * Log in | ||
+ | * Kies zwart-wit of kleur (EDU of ADM maakt niet uit) | ||
+ | * Upload het bestand | ||
+ | * Ga naar de afdeling grafiek (verdieping 3) | ||
+ | * Leg KASK-kaart op de printer | ||
+ | * Selecteer je budget. Privé of ART1 | ||
+ | * Klik op '' | ||
+ | * Selecteer je file | ||
+ | * Klik ' | ||
+ | |||
+ | |||
- | {{: | ||
- | Sanding 3D prints makes it appear matte | ||
===== Website ===== | ===== Website ===== | ||
Line 17: | Line 31: | ||
* child pages: item | * child pages: item | ||
+ | ===== Occulus Go ===== | ||
+ | |||
+ | standalone VR goggles | ||
+ | |||
+ | Troubleshooting: | ||
+ | |||
+ | When controller doesn' | ||
+ | - Press power and volume-down button | ||
+ | - Navigate to the factory reset option with the volume buttons | ||
+ | - press OK with the power button | ||
===== Assortments ===== | ===== Assortments ===== | ||
Line 39: | Line 63: | ||
* M10 | * M10 | ||
+ | |||
+ | ===== Join shared folder on Windows ===== | ||
+ | * Open new explorer window | ||
+ | * Right-click on 'This PC' | ||
+ | * Click on '' | ||
+ | * in ' | ||
+ | * Enter the username and password the shared folder is connected to | ||
+ | |||
+ | |||
+ | |||
+ | ===== Lumix GH5S Remote shutter release: | ||
+ | |||
+ | [[https:// | ||
+ | I used this circuit with the 4N25 optocoupler: | ||
+ | {{: | ||
+ | To use this with a 3.3V trigger signal, the resistor going to input 1 on the optocoupler should be around 50Ω. |